IHP F2460 User manual

1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
CONTEMPORARY FACADE KITS
GENERAL INFORMATION
The Contemporary Facade Kit is composed of two separate elements
(one base kit and one panel kit with trim) that are purchased separately.
Refer to Table 1.
NOTE: To complete one Facade a selection of one Base and one Panel
kit must be made.
The Panel must be installed on a properly positioned Gemini CD or
DRC3000 fireplace. Refer to Installation and Operation manual for detailed
instructions. Refer to Table 2 for facade significant dimensions.
INSTALLATION INSTRUCTIONS FOR CONTEMPORARY FACADE KITS
FOR USE WITH GEMINI CD AND DRC3000 FIREPLACES
HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 506020-32
Rev. A, 08/2016
A
B
D
C
E
F
Contemporary Facade Units
35” Models 40” Models
Description Cat. No. Model No. Cat. No. Model No.
Choose One Base Kit
Facade Base Black F2460 FBBK35CD F2462 FBBK40CD
Facade Base
Stainless F2461 FBSS35CD F2463 FBSS40CD
And Choose One Panel Kit
Facade Panel Black * F2464 FPBK35CD F2466 FPBK40CD
Facade Panel
Stainless * F2465 FPSS35CD F2467 FPSS40CD
Table 1
Facade Dimensions
ABCDEF
35” Model 44-1/2
(1130)
32-7/8
(835)
35-1/2
(902)
23-7/8
(606)
29
(737)
16
(406)
40” Models 49-1/2
(1257)
37-7/8
(962)
40-1/2
(1029)
28-7/8
(733)
34
(864)
21
(533)
Table 2
Figure 1
Start by locating the fireplace face brackets indicated by the arrows
at the top Figure 1 and the fireplace face foot slots indicated by the
arrows at the bottom of Figure 1. Proceed with the steps on Page 2.
INSTRUCTIONS
Base
Trim
Frame
Panel
* The panel kits include trim.
fire-parts.com

2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 1. Slide top trim pieces over flange of panel until seated squarely. Step 2. Slide side trim pieces into place (top will overlap slightly).
Repeat Step 1 and Step 2 for bottom and opposite side trim for panel.
NOTE: Remove protective flim from all stainless components
before installation.
Step 3. Plug lead wires into the IPI Switch on right side of
facade base.
fire-parts.com

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
3
Step 4a. Slide the foot tabs of the facade base into the slots (see Figure
1)on both sides near the bottom of the fireplace opening.
Step 4b. Tilting the facade base up on its foot tabs, secure the top by
engaging the three brackets (see Figure 1)on the face of the fireplace
with the three cut outs on the back top of the facade base.
(Black Base and Stainless Panel shown)
Step 5. Slide the tabs on the back of both sides of the facade panel
into the slots on the base.
Fireplace
Face
Bracket
Facade
Base
Cutouts
fire-parts.com

4
Printed in U.S.A. © 2015 Innovative Hearth Products
P/N 506020-32 Rev. A 08/2016
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also to discontinue colors, styles and products. Consult your local
distributor for fireplace code information.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
fire-parts.com