Ironwood WG32 User manual

WG32
PRINTER WAGON
06/07
IMPORTANT!
Assembly may require the assistance of
another person.
Before you begin assembly:
READ THE DIRECTIONS all the way through one
time. This will speed up the process and help you
understand the sequence of steps.
COUNT THE PARTS AND HARDWARE before
assembly. This ensures you have received all
necessary parts before you begin.
TOOLS: You may need a Phillips head screwdriver,
a medium slotted screwdriver or a plastic mallet. To
protect your new furniture from damage during
assembly, it is recommended to work on a
carpeted surface.
CAUTION: On assemblies requiring glue, make
sure the unit is assembled correctly before gluing.
Once this unit is assembled with glue, the
manufacturer will not be responsible for damaged
parts. Keep a damp cloth or sponge handy to wipe
off excess glue.
To care for this furniture, simply wipe with a cloth
dampened with glass cleaner containing ammonia-D.
In the event any parts are missing from
this package, send your name, address,
telephone number, and a description of
the missing part(s) to: PARTS, Box 1420,
Missoula, MT 59806 or call:
1-800-769-5693 or FAX [phone].

A
A
PARTS & HARDWARE DIAGRAM
Sides 05830841 1 ea.
Bottom 05830811 1 ea.
E
C
Top 05830801 1 ea.
Minifix Cam 909810 8 ea.
H4
Minifix Bolt 909834 8 ea.
H3
8x5/8 Phillips
Panhead Screw 988056 16 ea.
H2
Plate Caster 402050 4 ea.
H1
ASSEMBLED DISASSEMBLED
Using the Minifix System:
Insert the Minifix Cams into the
appropriate holes with the arrow
facing outwards as shown.
Using the #2 Phillips screwdriver,
rotate the Cam Devices a half turn
clockwise until snug.
To disassemble, turn the Cam
Devices counter-clockwise and
remove panels.
When screwing post into hole, Do
Not over tighten. Screw post down
until bottom face of post flange just
touches board surface.

#1
E
H1
H2
Place the Bottom Panel (E) face down on a clean, carpeted surface with the pre-drilled holes facing
up. Install four Plate Casters (H1) at each corner of the Bottom using Panhead Screws (H2) in the
pre-drilled holes as shown.
Place the two locking casters toward the front.
CE
TOP BOTTOM
H3 H3 H3 H3
Turn the Bottom (E) upright. Place the Top (C) face down with the pre-drilled holes facing up.
Screw four Minifix Bolts (H3) into the pre-drilled holes on the Bottom and four Minifix Bolts into
the pre-drilled holes on the Top.
Insert four Minifix Cams (H4) into each
Side (A). Make sure the arrow on each
Cam faces out as indicated.
#2
H1
H3
H4
H2
#3
A
H4
H4
H4
H4
OUT
OUT

Fit the Sides (A) over the Minifix Bolts (H3) already installed on the Bottom (E). Using a Phillips
screwdriver, rotate the Minifix Cams (H4) clockwise to secure in place.
#4
A
A
E
H4
H4
Place the Top (C) onto the sides, seating the Minifix Bolts of the Top into the Cam sockets on
the Sides. Using a Phillips screwdriver, rotate the Cams clockwise to secure the top to the
sides.
Your Printer Wagon is now assembled and ready for use.
#5
C
H4
H4