JSI Bourne User manual

Installation Instructions
Electrical
Worksurface Power - EC26
Page 1 of 2Bourne
Under Surface Power - EC27
• Remove clamping bracket from power unit.
• From top side of table, feed power cord through
cutout in worksurface and lower unit onto surface.
• Reattach clamping bracket from underside of table,
tighten four screws firmly.
• Locate center of table.
• Position power unit in center of table from
right to left and offset front of power unit back 1/8 ”
from front edge of table.
• Mount using four supplied screws.
Worksurface
Side View
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-BU007
5/1/16

Installation Instructions
Electrical
(continued)
Wire Management
Page 2 of 2Bourne
• Bourne tables with metal legs are designed
to route and conceal cords down to floor.
• The Leg Cap will need to be removed in which
the cord will be routed. See illustrations below.
Reattach
Leg Cap
Push Leg Cap straight
down to disengage clip.
Route cord
through leg.
Remove
Leg Cap
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-BU007
5/1/16
Use clips where
necessary to conceal
wires.