JSI Just Stack It User manual

Just Stack It! HANGING WARDROBE Assembly Instructions
Just Stack It! Hanging Wardrobe Assembly Instructions-061122.docx
1 | P a g e
ASSEMBLY INSTRUCITONS
1. Measure 1’from the inside edge of the Platform End Rail on the Crosspieces and hang brackets there.
2. Install the one screw in each bracket to secure them to the Crosspiece Rail.
3. Install an O-ring on the rod and insert the rod into the brackets.
4. Secure the rod in the brackets using the second O-ring or packing tape.
5. Cover your hanging clothes with the clear plastic bags and hang them on the rod.
6. Install additional Wardrobe KITS as needed 2’away from each other on the Crosspiece Rail.
INSTALL THE FIRST SET OF ROD BRACKETS
Hang the bracket on the inside of Crosspiece Rail
approximately 1’from the inside edge of the End Rail.
Install the second bracket on the opposite Crosspiece
Rail. Install the one screw in each bracket.
INSTALL THE FIRST O-RING ON THE HANGING ROD
Place an O-ring on the rod approximately 1-1/2”from
the end of the rod.

Just Stack It! HANGING WARDROBE Assembly Instructions
Just Stack It! Hanging Wardrobe Assembly Instructions-061122.docx
2 | P a g e
INSTALL THE HANGING ROD
Place the rod into both brackets as shown with the first
O-ring against the inside of the bracket on one side.
The rod should be flush with the outside edge of the
Crosspiece Rail.
INSTALL THE SECOND O-RING
Put the second O-ring on the oppososite side of the
bracket to capture the rod in place. You only need O-
rings on one of the brackets.
BAG AND HANG YOUR CLOTHES
Cut a small opening in the bottom of the clear bag.
Reach through the hole and grasp a bundle of hangers.
Spread the bag down over the clothes.
INSTALL ADDITIONAL WARDROBES
If needed, add additional wardrobe kits. Place the
brackets 2’apart from the first set. Note the brackets
are on the inside of the Crosspiece Rail.