JSI FLUX LOCKER User manual

INSTALLATION INSTRUCTIONS
INST-FL0015
NOTE: All screws provided must be installed for proper
installation and compliance with product warranty.
Recommended tools
ATTACHING A TOP PANEL
FLUX
Flux Locker Assembly
1. Align the top panel so that the
back of the panel is flush with
the back of the locker(s). The
panel should be centered
horizontally
2. Screw the top panel to the
locker(s) using #8 1-1/2”
Screws
Figure 1
ATTACHING A BACK/TOP PANEL
Hardware enclosed
#8 1-1/4”
FHP
(QTY Varies)
#8 1-1/2”
FHP
(QTY Varies)
1. Center the top/back panel. The
bottom of the back panel must be
flush with the bottom of the
locker(s)
2. Screw the back/top panel to the
back and top of the locker(s) using
#8 1-1/4” screws for the back and #8
1-1/2” screws for the top through
the pre-drilled holes
Figure 2
Figure 1
Figure 2
Level

INSTALLATION INSTRUCTIONS
INST-FL0015
NOTE: All screws provided must be
installed for proper installation and
compliance with product warranty.
FLUX
Flux Locker Assembly
Figure 1
Figure 2
1. Align the two lockers so that they are
flush on all sides
2. Screw the two lockers together using
the holes found on the inside of the
rightmost locker and the screws
provided
Figure 3
ATTACHING MULTIPLE LOCKERS