JSI FLUX OPEN PLAN Guide

INSTALLATION INSTRUCTIONS
INST-FL0032
NOTE: All screws provided must be
installed for proper installation and
compliance with product warranty.
Hardware Needed
Recommended Tools
FLUX OPEN PLAN
INSTALLATION AND ASSEMBLY
OF SLAT WALLS WITH
ACCESSORIES
#8 x 3/4” PHP Screws
1. Remove the peel strip from the face of the rubber bumper provided, then
place the bumper on the bottom of the slat wall tabs (Figure 1)
2. Slide the slat wall onto the worksurface in the desired location (Figure 2)
3. Secure the wall by screwing #8 x 3/4” screws into the pre-drilled holes on
the bottom of the slat wall (Figure 3)
Figure 1
Figure 2
#8 x 7/8”
Figure 3
Bumpers

INSTALLATION INSTRUCTIONS
INST-FL0032
FLUX OPEN PLAN
INSTALLATION AND ASSEMBLY
OF SLAT WALLS WITH
ACCESSORIES
1.Slide tabs on the end of the accessory being
attached into the slot on the wall (Figure 1)
2.Let the accessory rest on the wall (Figure 2)
Figure 1 Figure 2