JSI Flux User manual

Installation Instructions
Flux
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL003
6/1/18
Page 1 of 3
Adjustable Table Top Location
Recommended Tools
Hardware Used
#2 Phillips Head Bit
Screw Gun
Level
Underside of Top
5/16 ”x 1 1/4”
Hex Head Bolts,
#8 x 7/8”Flat Head Wood Screws
Socket
Wrench
1/2 ”
Socket
Center Mount Offset Mount
Center Mount Offset Mount
Step 1
• Carefully lay top upside down on a flat smooth surface.
• Align mounting plate to the set of pre-bored holes which
centers the mounting plate to the top. (See below)
• Fasten mounting plate to top using eight (8) #10 x 7/8”flat
head wood screws.
Step 1
• Carefully lay top upside down on a flat smooth surface.
• Align mounting plate to the set of pre-bored holes which will
offset the mounting plate to the table top. (See below)
• Fasten mounting plate to top using eight (8) #10 x 7/8”flat
head wood screws.
Centered
Underside of Top
Mounting Plate
Mounting Plate Offset
Flat Washers & Lock Washers
Note: The mounting plate will be shipped fastened to the table top in either center or offset location.
To change the mounting plate/table top location, please follow Step 1. If the mounting plate is
in desired location please proceed to Step 2.

Installation Instructions
Flux
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL003
6/1/18
Page 2 of 3
Adjustable Table Top Location
(continued)
Step 2
• Place top onto table column aligning the four
mounting holes. Using wrench, firmly secure
top to base using four (4) bolts, flat and lock
washers.
5/16 ”x 1 1/4”
Hex Head Bolt,
Flat & Lock Washers
Center Mount
Side View
Offset Mount
Side View

Installation Instructions
Flux
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL003
6/1/18
Page 3 of 3
Step 3
Route Electrical Wiring Adjustable Table Top Location
(continued)
Attach wire manager
to underside of surface
and route wire accordingly
Plug power cord into
nearest power outlet
Dongle
To height
control switch
To adjustable column