JSI CAAV User manual

INSTALLATION INSTRUCTIONS
NOTE: all screws provided must be
installed for proper installation and
compliance with product warranty.
Recommended tools
Hardware enclosed
4MM ALLEN WRENCH
5MM ALLEN WRENCH
CAAV
WING INSTALL
Left handed unit used for
Instructions - right will be opposite
UNIT WILL COME PACKED IN 2 BOXES:
•1ST box will contain the chair with screen
•2nd box will contain the wing
STEP 1:
•Use the 4mm and 5mm allen wrenches to remove
the connector bolts from the chair screen only –do
not remove the connector bolts from the wing
CHAIR WITH SCREEN:
CONNECTOR BOLTS
ARE PRE-INSTALLED
ON PANEL
WING WILL COME
WITH H-BRACKETS
PRE-INSTALLED

INSTALLATION INSTRUCTIONS
NOTE: all screws provided must be
installed for proper installation and
compliance with product warranty.
Recommended tools
Hardware enclosed
4MM ALLEN WRENCH
5MM ALLEN WRENCH
CAAV
STEP 2:
•Slide wing “H-Brackets” over end of the screen
•Align holes in the “H-Brackets” on the wing with the
holes in the screen (where the connector bolts had been
removed)
STEP 3:
•Insert the connector bolts thru each side of the “H-
Bracket” and start threading the bolts by hand until both
sets are started.
•Snug down the bolts using the 4mm and 5mm allen
wrenches. DO NOT OVER TORQUE. There will a slight
amount of play between the bolt heads and the bracket
to prevent damage to the bracket finish.
•Properly level unit using the leveling glides
•Install complete.
WING INSTALL
Left handed unit used for
Instructions - right will be opposite