JSI CAAV User manual

INSTALLATION INSTRUCTIONS
NOTE: all screws provided must be
installed for proper installation and
compliance with product warranty.
NO TOOLS REQUIRED
CAAV
IN SURFACE POWER INSTALL
STEP 1:
•Remove thumb nut from rear of EC46 unit and
remove both of the retainer brackets as shown.
•Keep the thumb nut
•You will discard the smaller of the 2 brackets
and keep the larger. The smaller is utilized in
applications other than work surfaces.
EC46 Power Unit shown
Discard Keep

INSTALLATION INSTRUCTIONS
NOTE: all screws provided must be
installed for proper installation and
compliance with product warranty.
NO TOOLS REQUIRED
CAAV
STEP 2:
•Locate the cutout in the top that power will be
installed in.
•Run the cord thru the cutout and place the unit
within the cutout
STEP 3:
•Slide bracket onto stud and fasten in place with the
thumb nut as shown
•Securely tighten down
•Installation complete
IN SURFACE POWER INSTALL