Ofs Porter User manual

Porter assembly instructions

2ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
Table of contents
Components 3
Planter assembly 4-7
Configuration notes 8
Adjusting planter connections 9-10

3ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
Components
4x panels
Tray liner
4x leveler
cam locks
Tray support
8x top/shelf
cam locks

4ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
1. Set two panels next to each other as shown. Each flange is labeled, so
ensure that you match them accordingly (A to A, B to B, etc.).
(Figure A)
2. Begin assembly with the leveler cam locks first. Insert a leveler cam lock
into the bottom hole from left to right. (Figure B)
Planter assembly
Figure A
Figure B
Panel label location
(A or B)

5ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
3. Engage cam by pivoting it upward until it stops. Assemble all four
panels in this manner. (Figure C)
4. Decide which height you want your tray at. If you want your tray in the
bottom position, move to Step 5 now. If you want your tray at the
middle height setting, skip to Step 5, then go to Step 6. (Figure D)
Note: Shelf orientation to be in middle or bottom configurations only.
Planter assembly continued
Figure C
Figure D
Middle or
bottom

6ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
5. For bottom tray position, Insert tray support from top. Then insert tray
liner. The support and tray will rest on the leveler cam locks. (Figure E)
Note: Tray limited to 100lbs
6. If a middle shelf is desired, use an extra set of top /shelf cam locks in
the center holes. This will bring your smaller plants up to a higher level.
(Figure F)
Planter assembly continued
Figure E
Figure F

7ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
7. Insert top cam through the holes at the top of every panel, joining two
panels together. (Figure E)
8. Engage cam by pivoting it downward until it clicks. (Figure F)
Planter assembly continued
Figure E
Figure F

8ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
Planters is intended to nest with other planters as shown here. (Figure A)
Configuration notes
In some configurations, your planter may end up being oset, as shown here.
(Figure B)
If you are unable to fix the problem by rotating a square planter, follow the
Adjusting planter connections steps to rebuild ONLY the rectangular planters.

9ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
Adjusting planter connections
1. Remove top cams. (Figure A)
2. Remove tray top and tray support from rectangular planters. (Figure B)
Figure A
Figure B
Cam lock
Tray liner
Tray support

10ofs.com imagine a place® 800.521.5381 Assembly instructions
Porter assembly instructions
3. Flip your planter upside down. (Figure C)
4. Move leveler cam locks to the bottom holes. (Figure D)
Adjusting planter connections continued
Figure C
Figure D
Move to
bottom