Ofs Staks slide-out storage User manual

Staks slide-out storage assembly instructions

2ofs.com imagine a place® 800.521.5381 Assembly instructions
Staks slide-out storage assembly instructions
Staks slide-out storage tower user guide
1. The SOSR/SOSL Storage Towers ship completed with no assembly required.
However, some installations may require gaining access to the inside of the cabinet
and/or making height adjustments to adapt to variations in floor surfaces.
2. To remove the inner slide out, first remove the adhesive cover on the back side of
the slide out, then insert a 6mm Allen wrench and turn clockwise to retract the
guide pin. Next, locate both orange latches on the bottom of the slide out and pull
inwards. With both latches now disengaged, the inner slide out is free and can be
pulled out completely from the cabinet. Reverse these steps to re-install.
3. After the outer cabinet has been leveled, cycle the slide out to ensure both of the
soft wheel casters on the bottom of the slide out are making contact with the floor
at all times. If the casters are up too high to touch the floor, or down too low causing
a bind during operation, then height adjustments need to be made. To adjust the
height of the caster, insert a 6mm Allen wrench and rotate as necessary to adjust
the height up or down.
6mm Allen
wrench
Guide pin
6mm Allen
wrench
Power cord
access hole
Latch