Saxby Lighting E27 LED GLS Manual

Instruction leaflet
E27 LED GLS
70849, 70850, 70851

Specification
Voltage: 240V 50Hz Lamp: 10W LED E27 GLS - 800lm IP rating: 20
70849: 4 step dimming
• Simplyswitchthelightonandofftodecreasethebrightnessofthebulb.Brightnesslevelsshownhere:-
www.saxbylighting.com SaxbyLightingLtd.BH233PE
70850: colour changing
• Whenthelightisfirstswitchedonthebulbisat3000Kbrightnesslevel.Ifthelightisswitchedoffandthen
onagain,thebrightnesslevelofthebulbincreasesto4000K.
70851: RGB
• Battery care: Donotrechargenon-rechargeablebatteries.Donotmixold&newbatteriesorbatteriesofdifferent
types.Donotuserechargeablebatteries.Alwaysremoveexhaustedbatteriesfromtheremotecontrol.Always
insertthebatterywiththecorrectpolarity.Donotshortcircuitthesupplyterminals.Thisproductissuitableforuse
byadultsonly.
• Toreplacethebattery,releasethecompartmentfrominsidetheremotecontrolbypushingtheleveratthebottom
leftofthecompartment.Pullthebatteryhousingoutandreplacetheexhaustedbatterywithanewone-makesure
thepolarityiscorrect.Thenslidethecompartmentbackinsidetheremotecontrol.
• Seebelowforfurtherbatteryreplacementinfoandinstructionsforuse.
Turn on the product
White 3000K LED on - all other
Switches between colours - each
1/4 second apart.
Switches between colours - each
3 seconds apart.
Smooth colour change -
one lap = 30 seconds
Smooth colour change -
one lap = 120 seconds
Decrease brightness
Increase brightness
Individual colour choice
Instructions for remote control
+
CR 2025
3V
+
CR 2025
3V
+
CR 2025
3V
+
CR 2025
3V
Iss.126072016