Saxby Lighting Flexline 73670 Manual

Instruction leaflet
Flexline Profile
73670, 73671

Thank you for purchasing this accessory. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference
Specification
www.saxbylighting.com
Iss.1 17072018
Saxby Lighting Ltd. BH23 3PE
Dimensions: 73670: 1002mm x 15mm x 6mm. 73671: 1000mm x 19mm x 19mm.
Please Note
• These profiles are designed for use with the following LED kits:
52305 Flexline 5m kit 12W warm white
52306 Flexline 5m kit 12W daylight white
73666 Flexline 5m kit CCT 24W
73667 Flexline 5m kit RGB 24W
• Please check other LED module dimensions before installing into these profiles.
Installation
• Choose an ideal place to mount the profile.
• Remove the 2 brackets from the fixing pack.
• Using the brackets as templates, mark and drill the position of the fixing holes.
• Ensure the mounting structure is capable of holding the weight of the product. Take care to avoid damaging any
concealed wiring and pipes.
• Attach both brackets to the chosen mounting surface using the provided screws.
• Remove the backing off of the chosen LED module strip and stick down inside the aluminium profile.
• Attach diffuser to the profile, sliding into the profile grooves.
• Place end caps onto the ends of the fitting.
• Push profile onto the brackets to secure.
• Your fitting is now ready for use.
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could damage the finish.
Care & Cleaning
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
For your safety, always switch off the supply before cleaning.
Safety information