Neopost IS-400 Series Parts list manual

COM 2COM 1COM 4COM 3
N2. Unpack your replacement
LAN Cable Power Cable Ink Cartridge Meter
Removal Installation
Disconnect the LAN Cable (f) by pressing and holding down the clip
and Power Cable (g) from either side of the machine
The machine must be disconnected from the
power supply before continuing to the next step!
5
Disconnect the Weighing Platform (e) by twisting
the thumbscrews and pulling from the machine
Make a note of which COM PORT (2 or 3)
you removed the weighing platform from!
COM 2COM 1COM 4COM 3
6
Please do not connect your replacement
machine to the power until step N6
Remove the Meter (i) by sliding towards you and lifting out
7
N1. Remove the components from your original machine
Remove Weighing Platform (e)
and Shelf (If applicable) (d)
2
Lift the top cover to reveal the
Ink Cartridge (h)
3
Press down below the word ‘TOP’ until you hear a ‘click’
then remove the Ink Cartridge (h)
4
Remove the Feed Table (b) by lifting the machine slightly and sliding down to detach and the
Catch Tray (c) by lifting it upwards and away from the machine
1
Remove your replacement machine (a) from the box and place
your original machine back into this box ready for collection
Caution: Product weighs 10.1kg,
please seek assistance before lifting
1
Machine components:
IS-400 Series Base
Product Replacement Guide Average Time Required: 20 minutes
Machine Base
Feed Table Catch Tray
Shelf
Weighing Platform
COM 2COM 1COM 4COM 3

N6. Attach your accessories N7. Switch on the machine
1st Inl. Lett
No service
11.02.16
£000.00
00000g
E
S
Mem:
The home screen should be displayed as shown.
If you have departments on your machine you will
need to select a department and enter your PIN
code if necessary
2
Congratulations
Your machine is ready to use!
For more information or if you experience
any issues please visit: kb.neopost.co.uk
IS-400 Series Base
Product Replacement Guide - Continued
Replace Weighing Platform (e) and
Shelf (if applicable) (d)
Turn on the machine using the switch behind
the Power Cable (g)
1
Lift machine slightly on the left hand side and align the hooks to attach the Feed Table (b) –
attach the Catch Tray to the right hand side of the machine (c)
1
N3. Insert the Meter
Place the Meter (i) into the machine compartment and push
backwards until it slots into position
2
Lift the cover of the replacement machine
to reveal the Ink Cartridge (h) and Meter
(i) locations
1
N4. Install the Cartridge
Insert the Ink Cartridge (h) at an angle into the machine with the ‘TOP’ and
‘LOCK’ stickers facing upwards. Push the Ink Cartridge (h) towards the back
of the machine until you hear a ‘click’ - close the cover of the machine
1
N5. Connect your Cables
Reconnect the Weighing Platform (e) connector into the previously
noted COM PORT (N1 step 6) on the rear of the machine. Then connect
the LAN Cable (f) and Power Cable (g) to either side of the machine
1
COM 2COM 1COM 4COM 3
To finish the replacement process the machine will now need to connect to our server. Please:
N8. Make a connection
2
Press Select ‘ONLINE SERVICES’ & press
Choose ‘GENERIC CALL’ & press
Press when the call has finished
Press key
1
Press Choose ‘AUDIT CALL’
Press and again to confirm
Press when the call has finished
Press key
2