aivituvin AIR 60 User manual

I
AIR 60
www.aivituvin.com
NSTRUCTION
MANUAL

Firmly secure all bolts,screws and knobs before use.
Reconfirm that all bolts,screws,and knobs are secure
every 90 days.
Fasten screws loosely during initial assembly. Do not
fully tighten screws until the item is completely
assembled.
Do not use or store this item in the proximity of open
flame or flammable/combustible chemicals.
Be aware that some parts are heavy and have sharp edges.
Be aware that moving parts can injure,crush and cut.
If any parts are missing,broken,damaged,or worn,stop
using this product until repairs are made and/or factory
replacement parts are installed.
Do not use this item in a way inconsistent with the
manufacturer’s instructions as this could void the
product warranty.
Please retain these instructions for future
NOTICE
01

02
PHILLIPS
SCREWDRIVER DRILL (RECOMMENDED) 2PERSON ASSEMBLY APPROXIMATELY 60MIN. ASSEMBLY
M3.5x60 mm SCREW
4PCS+1 spare
M3.5x35 mm SCREW
8PCS+1 spare
M3.0x16 mm SCREW
4PCS+1 spare
TOOLS REQUIRED
HARDWARE
P2 P4
P6
P5
Latch
1PC
P9
M4.0x40 mm BOLT
8PCS+1 spare
P8

03
T
PARTS
Roof of pen
2PCS
N
O
Bottom plate
1PC 1PC
Left pen panel
(close to the hutch)
P
1PC
Right pen panel
(close to the hutch)
Q
R
Left pen panel
(outside)
1PC 1PC
Right pen panel
(outside)
S
1PC
Side panel of pen

PRODUCT ASSEMBLY
01
Attach Part O& P to Part N by 4xP8 screws.
04
NP
O
P8 X4
02
Attach Part Q& R by 4xP2 screws.
Q
R
P2 X4

PRODUCT ASSEMBLY
Attach front panel Part S by 4xP8 screws.
03
05
P8 X4
S
04
Attach pen roof 2xPart T by 8xP4 screws.
P4 X8
Tx2

PRODUCT ASSEMBLY
05
Attach the lock P9 by 4XP6.
06
P6 X4
P9 X1

WARNING
Manufacturer and seller expressly disclaim any and all liability for personal
injury,property damage or loss,whether direct,indirect,or incidental,resulting from
the incorrect attachment,improper use,inadequate miantenance,or neglect of this