Neopost CS-200 User manual

Fee-Franking Machine
Base Swap Guide
CS-200

Page 1
CS-200 Base Swap Process
The following steps will guide you through the removal of the base and installation of a new
base.
Replacing the Base Base Components
The following steps are performed when replacing the base
1. Disconnecting the old base
2. Connecting the new base
3. Installing the new base
CS-200 – Fee-Franking Meter
Base
Note: It is extremely important that you follow the steps outlined in this document
Disconnecting The Old Base
1. Disconnect the power cable from the wall outlet.
This will turn off the CS-200.
2. Disconnect the power adapter from the
CS-200.
Put the power adapter aside; it will be connected to the new
base.
3. Disconnect the USB cable on the internet adapter or
phone modem from the CS-200.
Put the internet adapter or phone modem aside.

Page 2
4. Place the CS-200 onto its back to access the PSD cover.
Open the PSD cover by pushing down on the tab.
5. Remove the PSD by sliding it up and then out of the base.
Put the PSD aside; it will be re-installed in the new base.
Close the PSD cover.
Connecting The New Base
1. Open the base door of the new CS-200 and remove the
cardboard packaging.
Close the base door.
Do not install the ink cartridge at this time.
2. Place the new CS-200 onto its back to access the PSD
cover.
Open the PSD cover by pushing down on the tab.
3. Re-install the PSD by sliding it in and then down. Close the
PSD cover. If the PSD cover does not close properly, the
PSD is not installed correctly.
4. Turn the new base back to an upright position.

Page 3
5. Reconnect the USB cable on the internet adapter or phone
modem to the USB port on the new CS-200.
6. Connect the power adapter to the back of the new CS-200.
7. Connect the power cable to the wall outlet. This will turn on
the CS-200.
Installing The New Base
1. Press “Next” to continue to install the new
base.
2. Ensure the LAN connection or phone modem
is connected to the base and the cable from the
internet adapter or analogue modem is
connected to the internet or phone outlet. Press
“NEXT”.

Page 4
3. Depending on your connection type, one of
the following will be displayed:
- LAN (Internet)
- Modem
Press “OK”.
4. To check the connection to the server press
“OK” or “Continue”.
5. The call is connecting to the server.
Do not interrupt this process.
7. Press “OK” for the machine to establish a
connection to the server to activate the base.
8. The transaction is in progress.
Do not interrupt this process.
9. Transaction successful.
Press “OK” to continue.
11. Press “OK” to begin the Headset
Replacement Process

Page 5
12. It is now time to install the headset.
Press “OK” to continue.
13. To Install the headset, Open the front Cover
14. Pull the Blue lever to the open position
15. Fit the headset and then click the blue lever
back to the closed position
16. Select “OK” to carry out the headset
alignment process
17. Place an envelope into the print area
towards the back right corner. The unit will
perform a test print. When the process is
complete remove the envelope. You may have
to carry this test out several times to align the
head correctly.

Page 6
18. Select the letter that indicates the
straightest line and then select “OK”
19. Press “Yes” to restore the settings of your
previous base.
20. The transaction is in progress.
Do not interrupt this process.
21. The data has been successfully restored.
Press “OK”.
22. The base replacement process has now
been completed. Press “OK”.
Before processing mail, disconnect the power
cable from the wall outlet and reconnect it.

A0013336/A - 01/02/2015