Neopost ij25 User manual

IJ-25, WJ20 - Replacing The Ink Cartridge
The unit must be powered on when replacing the Ink Cartridge.
To replace the Ink Cartridge on the IJ-25, WJ20 follow these
steps:
1. From Ready mode press MENU and scroll (< >) until the display reads CARTRIDGE.
2. Press OK to confirm.
3. Scroll (< >) to REMOVE.
4. Press OK to confirm. The display will read:
5. Open the machine top cover upwards to gain access to the Ink Cartridge.
V
iew 1
V
iew 2
V
iew 3
Page 1 of 4

6. Open the blue latch to the right to release the Ink Cartridge.
7. Remove the Ink Cartridge by gripping the top as shown and pulling out.
Page 2 of 4

8. Remove the new cartridge from its packaging and remove the blue tape that protects that
Ink Cartridge.
9. Place the new cartridge into its holder and press gently at the bottom of the cartridge with
your thumb until it is fully inserted into the machine.
10. Close the blue latch by pushing it to the left until it locks the carriage in place.
Page 3 of 4

11. Close the top cover and press OK.
You may now be prompted to run a Test Print.
Page 4 of 4